Frequently Asked Questions and Solutions Of Layer Cages

May 19, 2018

Egg cage failure and troubleshooting

1. When the caged cage is used for defecation, only the rollers are turned and the belt is not moved.

Egg cage failure reason: may be due to excessive chicken manure; rubber roller and drive roller is not tight; there is foreign matter stuck in cleaning tape.

Egg cage removal methods: should be regularly run belt; tighten the bolts at both ends of the drive roller; remove foreign bodies.

 Frequently Asked Questions and Solutions Of Layer Cages

2. The skip does not go.

The fault of the egg cage: the driving rotation, the pull rope does not move; the positioning plate on the driven wheel is not in contact with the limit switch; the track wheel and the guide rails crowd; the motor is damaged.

Remedy: Turn the skip of the skip and tighten the drawstring; adjust the position of the stroke switch so that it touches; correct the guide rail so that the cage is in parallel; replace the motor.

 

3. The chicken droppings on the feces tape are thin.

The cause of the malfunction: the drinking water leaks the hen cage; the connection to the sink is not well sealed; the chicken is diarrhea.

Remedy: replace the egg cage waterer; will seal the joint sealant; medication medication.

 Frequently Asked Questions and Solutions Of Layer Cages

4. The rate of broken eggs is high.

Cause of failure: chicken quail eggs; thin shell; broken egg claws on the automatic egg catcher; collided eggs falling from the caged cage with the egg on the egg belt; eggs coming out of the automatic egg collector Eggs collided on the central egg drop line.

Remedy: Use electric shock lines; replace the feed formula; find the broken egg hen cage broken egg replacement claw; use the block line; adjust the egg puller height, make it buffer.

 

5. Cleaning belt drift.

Cause of failure: The rubber roller and the driving roller are not parallel; the cleaning tape has different lengths at both ends; the frame is not straight.

Remedy: Adjust the bolts at the two ends of the hen cage rubber roller to make it parallel; re-align welding at the connection; recalibrate the cage.

 

Abby    

M: +86 180 3191 8950  

E: abby@qunkunmetal.com/qun@qunkun.net

W: www.qunkun.net

 

Pre: The introduction of plucker machine

Next:Comparison of ladder cages and battery cages

SEND YOUR MESSAGE TO US

(* Guarantee your email safe absolutely)

TOP